Assembly Instruction

2 Remove drawers from top assembly as shown and set
aside.
3 Fit pre-assembled dowels of partition into
corresponding holes of bottom panel as shown. Secure
bottom panel to partition with 2 large screws using a
phillips head screwdriver. Do not over tighten the screws.
4 With the assistance of another adult, attach top
assembly to assembled unit as shown with 2 small flat
washers, 2 spring washers and 2 small bolts. Secure, but
do not over tighten, the bolts.
NOTE: Do not over
tighten the bolts
1 A) Insert 2 barrel screws into left and right side panels.
Secure, but do not over tighten, barrel screws with a flat
head screwdriver. Make sure to align hole of each barrel
screw so it faces the ends of each panel as shown.
B) Insert 2 barrel nuts into crossbar as shown. Using a
screwdriver, align hole of each barrel nut with the nearest
edge with holes.
A
B
NOTE: Make sure
hole of barrel nut
aligns with nearest
edge with holes
NOTE: Do not over tighten
the barrel screws
NOTE: Make sure hole
of barrel screw faces
end of panel
NOTE: Do not over
tighten the screws
Made in Vietnam - r06 Page 2 of 5
TRESTLE SIDEBOARD
bottom
panel
partition
top
assembly
top
assembly
left side
panel
right side
panel
crossbar
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com