Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
TOSCANA KITCHEN CART
Page 5 of 7
Made in USA - r03
15 A. Attach the drawer back to left and right drawer
sides with four 1-1/4"x #8 screws. Make sure slots on the
bottom of each panel are aligned.
B. Slide drawer bottom into slot, finished side up.
C. Insert 1 barrel nut into each drawer side as shown,
making sure hole in barrel nut is aligned with hole in drawer
side.
14 A. Fasten the magnetic catch to the left front leg
using the screws from the magnetic catch packet.
B. Attach the door to the right front leg with four 1/2"
x #5 screws.
13 A. Attach 2 hinges to the door with two 1/2"x#5
screws per hinge. Make sure the knuckle of the hinge is
oriented as shown. Secure with a phillips head screwdriver.
B. Attach magnet plate to the door with the screw
included in the magnetic catch packet.
A
B
A
B
C
12 With the assistance of another adult, place assembly
upright.
A. Attach 2 drawer glide supports to the inside of the
side panels with two 1-1/4"x#8 screws per support.
B. Attach the drawer glides to the drawer glide supports
with two 5/8" x #6 screws as shown.
IMPORTANT NOTE:
The knuckle of each
hinge must face out
and overlap the door
for proper fit. If the
hinge is not properly
oriented the door will
not close.