Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
TOSCANA KITCHEN CART
Page 2 of 7
Made in USA - r03
3 A. lnsert 2 barrel nuts into the top side brace as
shown. Make sure holes in each barrel nut are aligned with
holes on short edge of brace.
B. Insert 2 barrel nuts and 2 long steel pins into the
bottom side brace.
2 Insert 1 caster insert into the bottom of each leg as
shown. Gently tap with a hammer if necessary.
1 A. Insert 5 screw posts into the right back leg as shown. Secure each post with a flat head screwdriver.
B. Insert 3 screw posts in right front leg and secure with a screwdriver.
C. Insert 3 screw posts in left front leg and secure with a screwdriver.
D. Insert 5 screw posts into the left back leg and secure with a screwdriver.
A
Right
Back Leg
B
Right
Front Leg
C
Left
Front Leg
D
Left
Back Leg
A
B
Make sure holes
in barrel nuts align
with holes in edge
IMPORTANT INSTALLATION NOTE FOR
INSTALLING SCREW POSTS
a. Dip threads of the screw post in vegetable oil.
b. Align threaded end of post with the corresponding
hole in the wood. Tap on the slotted end with a
hammer until threads enter, then fully tighten using a
flat head screwdriver. DO NOT TRY TO HAMMER
THE POST ALL THE WAY IN AS IT WILL STRIP THE
POST HOLE AND NOT BE AN EFFECTIVE
CONNECTOR.
c. When solid shaft of post hits wood, back the post
out approximately 1/2 turn with the flat head
screwdriver.