Assembly Instruction

Made in China - r06 Page 3 of 3
TIVOLI CORNER CABINET
small wall
screw
large wall
screw
plastic
anchor
wall
strap
mounting
bracket
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
WALL MOUNTING INSTRUCTIONS
For added safety and stability, it is recommended that the
wall mounting hardware be installed. For safe mounting, it
is essential to use wall anchors appropriate to your wall
type (i.e. plaster, drywall, concrete, etc.). Mount to wood
studs whenever possible.
A) Attach 2 mounting brackets to assembled unit as
shown, using 2 small screws.
B) Determine the final location of unit. Mark position on
the wall, approximately 2" below the bracket mounted to
the back of the unit.
C) Drill a pilot hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller in
diameter than the anchor. Insert plastic anchors into hole
and secure using a phillips screwdriver.
D) Attach the mounting bracket to the wall by inserting 1
large screws through the mounting bracket and into each
plastic anchor in the wall.
E) Place the unit so the mounting bracket on the back
edge is aligned with the mounting bracket on wall.
F) Lace one end of the wall strap through both brackets,
and into the other end of the strap.
G) Pull the strap tightly until secure.
Repeat steps for remaining wall mounting hardware.
Wall mounting assembly is now complete.
NOTE: If you are unsure about your wall
type or what mounting method you
should use, consult a qualified
professional or your local hardware store.
A
C
D
F
CLEANING & CARE
Clean surfaces with a dry or damp soft
cloth. Do not use abrasive cleaners. Do
not use furniture wax or polish as the unit is
finished with a protective clear lacquer.