Assembly Instruction

3-WAY LAUNDRY SORTER
Made in China - r06 Page 2 of 3
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
1 A) Insert 2 barrel nuts into each top crossbar. Using a flat head
screwdriver, align holes of each barrel nut with holes in crossbars.
B) Attach 2 top crossbars to outer left and right side frames with
4 bolts and 8 washers per side as shown. Using a allen wrench,
make sure each bolt engages each barrel nut. Loosely secure bolts.
2 With the assistance of another adult, attach
top panel to outer left and right side frames
with 8 large screws as shown. Secure, but do
not over tighten, screws using a phillips head
screwdriver.
3 A) Insert 2 barrel nuts into each back crossbar.
B) Attach 2 back crossbars to outer left and right side
frames with 4 bolts and 8 washers per side as shown.
At this point, fully secure, but do not over tighten, all bolts
using a allen wrench.
4 With the assistance of another adult, position unit as
shown. Fully extend each glide as shown. Attach 2 glides
to outer left and right side frames with 3 smalls screws
per side. Secure, but do not over tighten, screws using a
screwdriver.
NOTE: Do not over
tighten the bolts
top crossbar
A
NOTE: Make sure
holes on each barrel
nut are aligned
with holes in
crossbars
outer right
side frame
outer left
side frame
NOTE: Do not over
tighten the screws
top panel
back crossbar
glide
NOTE: Do not over
tighten the screws
NOTE: Make sure inner
glide is pulled out of
outer glide as shown
top
crossbar
DETAILED
SIDE VIEW
back crossbar