Assembly Instruction

SUMMIT HUTCH
Made in China - r04 Page 2 of 5
1 A) Insert 4 cams into bottom panel as shown.
Make sure arrows on each cam point towards nearest
edge with holes.
B) Insert 2 cam screws into left/right side panels as
shown. Secure cam screws with a phillips head
screwdriver.
2 Fit pre-attached dowels of bottom panel into
corresponding holes of left/right side panels as
shown. Using a screwdriver, turn cams clockwise until
they securely engages each cam screw.
Make sure arrows
on each cam point
towards nearest edge
with holes
A
B
bottom panel
left/right
side panel
bottom
panel
right side
panel
left side
panel
3 Fit pre-attached dowels of assembled unit into
corresponding holes of top panel. Attach top panel
with 4 bolts, 4 spring washers, and 4 flat washers
as shown. Secure bolts with a screwdriver.
4 With the assistance of another adult, carefully
position assembled unit as shown. Attach back panel
with 20 small screws as shown. Secure screws with a
screwdriver.
back
panel
top
panel
NOTE: Make
sure grooves of
top/bottom panel
are in front.
Customer Service 800.967.6696 | www.crateandbarrel.com