Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com

Made in China R04

Page 4 of 4

SPRINGDALE

TALL CABINET

WALL MOUNTING INSTRUCTIONS

For added safety and stability, it is recommended that

the wall mounting hardware be installed. For safe

mounting, it is essential to use appropriate toggle or

molly bolts for your wall type. Mount to wood studs

whenever possible.

A) Attach bracket to top center of cabinet with wood

screw, using Phillips head screwdriver to tighten.

B) Mark location on wall approximately 2" below the

bracket mounted to the back of cabinet.

C) Drill a pilot hole into the wall stud. If no wall stud is

available, drill a hole into the wall that is slightly smaller

in diameter than the anchor. Gently tap anchor until

flange is flush with the wall.

D) Attach other bracket by inserting large screw

through bracket and into anchor on the wall.

E) Place unit so the bracket on the back edge is in line

with the bracket on the wall.

F) Lace one end of the wall strap through one bracket

then the other, bringing both ends together.

G) Ensure that the strap is secure.

Place unit in its final location. If the floor is uneven or

the door doesn't appear square in the case frame,

adjust levellers on the underside of the legs up or

down to compensate.

Assembly is now complete.

CLEANING AND CARE

Clean surfaces with a dry or damp soft cloth.

Do not use abrasive cleaners. Do not use

furniture wax or polish as the unit is finished with

a protective clear lacquer.