Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
Made in China R05 Page 4 of 4
A) Insert 8 shelf pins into side panels at desired level.
B) Place 2 adjustable shelves into unit, make sure
grooves are toward the back.
Fit the bottom rollers of the right door panel into
back groove and left door panel into the front groove
at the top and base of the cabinet assembly. Tilt the
doors up into position, depressing the levers at the
tops of the doors. Fit the door into the corresponding
grooves in the top panel and release the levers.
Assembly is now complete.
SPRINGDALE
SLIDING DOOR CABINET
10
11
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as
the unit is finished with a protective clear lacquer.
A
B
WALL MOUNTING INSTRUCTIONS
For added safety and stability, it is recommended that the
wall mounting hardware by installed. For safe mounting, it
is essential to use appropriate fasteners for you wall type.
Mount to wood studs whenever possible.
A) Attach bracket to top center of cabinet with 1 medium
screw, using Phillips head screwdriver to tighten.
B) Mark location on wall approximately 2" below the
bracket mounted to the back of cabinet.
C) Drill a pilot hole into the wall stud. If no wall stud is
available, drill a hole into the wall that is slightly smaller in
diameter than the anchor. Gently tap anchor until flange is
flush with the wall.
D) Attach other bracket by inserting pan head screw
through bracket and into anchor on the wall.
E) Place unit so the bracket on the back edge is in line with
the bracket on the wall.
F) Lace one end of the wall strap through one bracket then
the other, bringing both ends together.
G) Ensure that the strap is secure.