Assembly Instruction
SPENCER PEDESTAL EXTENSION TABLE
Made in China R02 Page 2 of 3
3 A) With the assistance of another adult, position unit
upright. Carefully fit mounting panel onto pedestal as
shown by aligning pre-assembled bolts with
corresponding holes.
B) Secure pedestal assembly with 4 hex nuts, 4 spring
washers, and 4 flat washers using a hex wrench.
5 With the assistance of another adult, position
tabletop face down onto a padded surface. Carefully
fit pedestal assembly onto tabletop. Fully tighten with
hardware removed in step 1 (8 bolts, 8 spring
washers, and 8 flat washers) using a Phillips head
screwdriver. Assembly is now complete.
2 Fit 4 legs into pedestal by aligning pre-assembled
bolts with corresponding holes as shown. Secure
each leg with 2 hex nuts, 2 spring washers, and 2
flat washers using a hex wrench.
4 A) With the assistance of another adult, carefully fit
mounting panel onto pedestal as shown by aligning
pre-assembled bolts with corresponding holes.
B) Secure pedestal assembly with 4 hex nuts, 4
spring washers, and 4 flat washers using a hex
wrench.
NOTE: Make sure pre-
assembled small square
panel on mounting panel
is facing downwards.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth.
Do not use abrasive cleaners. Do not use
furniture wax or polish as the wood is finished
with a protective clear lacquer.
Customer Service 800.967.6696 | www.crateandbarrel.com
A
B
B
A
B