Assembly Instruction

drawer
back
9 A) Attach drawer back to drawer left and right
side panels with 2 large screws per side as shown.
Make sure notches face out and are at the bottom of
the back panel as shown.
B) Adjust drawer bottom to make sure space
between inside of glide locking device and inside
edge of side panel is even.
C) Secure drawer bottom to drawer back and front
with 6 small screws as shown. Repeat steps 6-8 for
remaining drawer assemblies.
A
B
C
NOTE:Make sure notches face
out and are at the bottom of the
back panel as shown
drawer
bottom
C
RONAN 4 DRAWER CHEST
Made in Indonesia - r11 Page 4 of 4
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
locking device
10 Fully extend top drawer glides of assembled
unit. Carefully set 1 drawer assembly on top of
extended drawer glides. Push drawer assembly into
assembled unit until locking devices of drawer
bottom engage drawer glides of assembly. Repeat
for remaining drawer assemblies.
Assembly is now complete.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as
the wood is finished with a protective clear lacquer.
drawer glide
drawer
assembly