Assembly Instruction

RONAN 4 DRAWER CHEST
Made in Indonesia- r11 Page 2 of 4
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
A
bottom
panel
1 A) Place top panel onto a clean, padded surface. Insert
6 wood dowels and 4 cam screws into top panel as
shown. Secure, but do not over tighten, cam screw with a
phillips head screwdriver.
B) Insert 4 cams and 2 wood dowels into bottom panel as
shown. Make sure arrows on each cam point towards
nearest edge with holes.
2 Insert 2 cams, 2 cam screws and 8 wood dowels
into left and right side panels as shown.
B
3 A) Fit wood dowels of left side panel into correspond-
ing holes of 3 front crossbars as shown.
B) Fit wood dowels of left side panel into corresponding
holes of bottom panel as shown. Using a screwdriver,
turn each cam clockwise until it securely engages each
cam screw. Repeat steps 3A-3B for right side panel.
NOTE: Make sure
arrows on each cam
point towards nearest
edge with holes
NOTE: Do not over
tighten the cam screw
right side
panel
left and right
side panels
front
crossbar
top
panel
left side
panel
bottom
panel
NOTE: Make sure crossbar
of bottom panel faces back
as shown
A
B
glides
4 With the assistance of another adult, place assembled
unit upright. Carefully cut tape and remove from glides.