Assembly Instruction

ManualsBrandsCrate & Barrel ManualsStorage FurnitureCrate & Barrel Ronan Four-Drawer Chest

COMPONENTS

Made in Indonesia - r11 Page 1 of 4

Thank you for purchasing the Ronan 4 Drawer Chest.

This page lists all the contents included in the box.

Please take time to identify the hardware as well as the

individual components of this product. As you unpack

and prepare for assembly, place the contents on a

carpeted or padded area to protect them from damage.

Note: 2 people are required to safely assemble this product.

RONAN 4 DRAWER CHEST

1 - back

crossbar

1 - top panel

4 - drawer

backs

2 - side panels

(1 left, 1 right)

3 - front

crossbars

ASSEMBLY HARDWARE

TOOLS REQUIRED

Missing hardware?

Please call 800.606.6387 for replacements.

24- wood

dowels

phillips head screwdriver

1 - bottom

panel

(We recommend the use of hand tools instead power tools)

48 - small

screws

32 - large

screws

8- drawer

side panels

(4 left, 4 right)

4 - drawer bottoms

4 - drawer

fronts

8 - cam

screws

8 - cams

2 - back panels

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

Summary of content (4 pages)

PAGE 1
RONAN 4 DRAWER CHEST ASSEMBLY HARDWARE 24- wood dowels 48 - small screws 32 - large screws 8 - cam screws Missing hardware? Please call 800.606.6387 for replacements. 8 - cams TOOLS REQUIRED Thank you for purchasing the Ronan 4 Drawer Chest. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product.
PAGE 2
RONAN 4 DRAWER CHEST NOTE: Do not over tighten the cam screw NOTE: Make sure arrows on each cam point towards nearest edge with holes A panel top B bottom panel left and right side panels 1 A) Place top panel onto a clean, padded surface. Insert 6 wood dowels and 4 cam screws into top panel as shown. Secure, but do not over tighten, cam screw with a phillips head screwdriver. B) Insert 4 cams and 2 wood dowels into bottom panel as shown.
PAGE 3
RONAN 4 DRAWER CHEST NOTE: Do not over tighten the screws B top panel NOTE: Make sure crossbar of top panel faces front as shown A crossbar back back panel back panel 5 A) Fit wood dowels of bottom panel into corresponding hole of back crossbar. B) Fit wood dowels of top panel into corresponding holes of left and right side panels. Secure all cams. 6 Attach 2 back panels to assembled unit with 12 small screws per back panel as shown, using a screwdriver. Do not over tighten the screws.
PAGE 4
RONAN 4 DRAWER CHEST 9 A) Attach drawer back to drawer left and right side panels with 2 large screws per side as shown. Make sure notches face out and are at the bottom of the back panel as shown. B) Adjust drawer bottom to make sure space between inside of glide locking device and inside edge of side panel is even. C) Secure drawer bottom to drawer back and front with 6 small screws as shown. Repeat steps 6-8 for remaining drawer assemblies.