Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
2 A. Slip leg assembly A through leg assembly B as
illustrated. Make sure the pin of leg A fits into the hole on
leg B.
B. Secure the 2 leg assemblies together with 1 bolt and 1
hex nut. Tighten with a phillips head screwdriver.
A
B
Make sure pin of
leg frame A fits into
hole of leg frame B
QUANTUM DROP-LEAF TABLE
Page 2 of 2
Made in Canada - r01
4 A. Lift the leaf table tops to the same level as the
center tabletop.
B. Reach under and pull slide bars out to maximum
extension under each leaf.
C. Gently release leaves to rest on slide bars.
3 Place leg assembly into position over pre-drilled holes
in tabletop. Loosely insert 4 wood screws per leg.
After the base is in its final position, fully tighten all wood
screws with a phillips head screwdriver.
With the assistance of another adult, lift table upright.
Assembly is now complete.
x 16
EXTENDING THE DROP-LEAVES:
A
B
VIEW FROM
BELOW
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth.
Do not use abrasive cleaners.
CAUTION: Do not sit or stand on the table. Total weight
capacity not to exceed 75 lbs.