Assembly Instruction

left and right
side frames
B
A
NOTE: Do not over
tighten the cam screws
left side
frame
B
A
right side
frame
B
A
B
A
Made in China - r03
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
ROLL OUT DESK
Page 2 of 3
2 Insert 2 cam screws and 5 wood dowels into left and
right side frames as shown. Secure, but do not over tighten,
cam screws using a phillips head screwdriver.
3 A) Fit wood dowels of left side frame into corre-
sponding holes of front and back crossbar. Using a
phillips head screwdriver, turn cams clockwise until
each cam securely engages each cam screw.
B) Fit wood dowels of left side frame into corresponding
holes of back panel. Secure back panel with 1 bolt, 1
spring washer and 1 flat washer, using an allen
wrench. Do not over tighten the bolts.
back
crossbar
front
crossbar
back
panel
5 Place desktop onto a clean, padded surface. With
the assistance of another adult, fit dowels of desktop
into corresponding holes of assembly. Secure desktop
with 7 bolts, 7 spring washers and 7 flat washers,
using an allen wrench. Place assembled unit upright.
4 A) Fit wood dowels of right side frame into correspond-
ing holes of front/back crossbar and back panel. Secure all
cams.
B) Secure back panel to right side panel with 1 bolt, 1
spring washer and 1 flat washer, using an allen wrench.
NOTE: Do not over
tighten the bolts
back
crossbar
front
crossbar
back
panel
desktop