Assembly Instruction

PIVOT HUTCH
Made in Vietnam - r03 Page 5 of 5
back mirror
assembly
Customer Service 800.967.6696 | www.crateandbarrel.com
A
C
medium
screw
wall
bracket
plastic
anchor
large
screw
wall
strap
D
F
wall
bracket
Safety Mounting Instructions
For added safety and stability, it is recommended
that the wall mounting hardware be installed. For
safe mounting, it is essential to use wall anchors
appropriate to your wall type (i.e. plaster, drywall,
concrete, etc.). Mount to wood studs whenever
possible.
A) Attach wall bracket to top of bookcase using 2
medium screws as shown.
B) Determine the final location of bookcase. Mark
position on the wall, approximately 2" below the
wall bracket mounted to the back of the cabinet.
C) Drill a hole in the wall stud. If the wall stud is
not available, drill a hole in the wall that is slightly
smaller in diameter than the anchor. Gently tap the
plastic anchor until the flange of the anchor is
flush with the wall.
D) Attach wall bracket to the wall by inserting 2
large screws, and into the plastic anchor in the
wall.
E) Place the unit so the wall brackets on the back
edge are aligned with the wall brackets on the wall.
F) Lace one end of the wall strap through both
brackets, and into the other end of the strap.
G) Pull the strap tightly until secure.
H) Repeat steps A-G for remaining wall brackets
and wall straps.
NOTE:
If you are unsure about your wall type or what
mounting method you should use, consult a
qualified professional or your local hardware
store.