Assembly Instruction

PIVOT HUTCH
Made in Vietnam - r03 Page 2 of 5
1 Attach bottom panel and partition with 2 bolts, 2
spring washers, and 2 flat washers as shown.
Secure bolts with a phillips head screwdriver.
2 Fit dowels of partition into corresponding holes of
back panel as shown.
partition
bottom
panel
back panel
left side
panel
right side
panel
front
frame
NOTE: Make sure “THIS SIDE UP” labeled
on bottom panel is facing toward the
partition when assembling as shown
Customer Service 800.967.6696 | www.crateandbarrel.com
3 Attach left/right side panels to assembled unit
with 6 bolts, 6 spring washers, and 6 flat washers
as shown.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.
4 Fit dowels of assembled unit into corresponding
holes of front frame. Secure front frame with 6 bolts,
6 spring washers, and 6 flat washers as shown.
front
frame
frame
support
4 Secure left/right side panels to bottom panel of
assembled unit with 4 bolts, 4 spring washers, and 4
flat washers as shown.
4 Remove frame support from front frame as shown.
With a screwdriver, turn pre-attached bolts
counter-clockwise to detach. Set frame support and
hardware aside and discard.