Assembly Instruction

PATERSON CORNER MEDIA STAND

Made in China - r12 Page 2 of 6

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

1 A) Fit 13 wood dowels into top panel as shown.

B) Insert 6 cam screws into base as shown. Secure, but

do not over tighten, cam screws using a phillips head

screwdriver.

3 Fit pre-installed dowels of top panel into corresponding

holes of back panel. Secure back panel with 2 small

bolts as shown.

4 Fit pre-installed dowels of top panel into corresponding

holes of remaining large side panel. Secure large side

panel with 2 small bolts as shown.

2 Fit pre-installed dowels of top panel into correspond-

ing holes of large side panel. Secure large side panel

with 2 small bolts as shown, using a phillips head

screwdriver. Do not over tighten the bolts.

top panel

NOTE: Do not over

tighten the bolts

back panel

large

side panel

NOTE: Make sure

ledge on panel is

positioned as shown

top panel

large

side panel

NOTE: Make sure

ventilation holes of panel

are positioned as shown

NOTE: Do not over

tighten the cam screws

base