Assembly Instruction

Page 5 of 5
Made in China - r12 Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
PATERSON MEDIA STAND
OPTIONAL WALL MOUNTING INSTRUCTIONS:
For added safety and stability, it is recommended that the
wall mounting hardware be installed. For safe mounting, it
is essential to use wall anchors appropriate to your wall type
(i.e. plaster, drywall, concrete, etc.). Mount to wood studs
whenever possible.
A) Attach 1 anti-tip bracket to top of unit as shown, using
2 small screws.
B) Determine the final location of unit. Mark position on the
wall, approximately 2" below the anti-tip bracket mounted to
the back of the unit.
C) Drill a pilot hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller in
diameter than the anchor. Gently tap the plastic anchor
until the flange of the anchor is flush with the wall.
D) Attach the wall bracket to the wall by inserting 1 large
screw through the wall bracket and into the plastic anchor
in the wall.
E) Place the unit so the anti-tip bracket on the back edge is
aligned with the wall bracket.
F) Lace one end of the wall strap through both brackets,
and into the other end of the strap.
G) Pull the strap tightly until secure.
Wall mounting assembly is now complete.
NOTE:
If you are unsure about your wall type or what
mounting method you should use, consult a
qualified professional or your local hardware
store.
A
C
D
F
anti-tip
bracket
small
screw
wall
bracket
plastic
anchor
large
screw
wall
strap