Assembly Instruction

PATERSON MEDIA STAND
Made in China - r12 Page 2 of 5
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
1 Insert 6 wood dowels into top panel as shown.
3 Carefully slide back panel into corresponding grooves
of assembled unit as shown. At this point, secure all small
bolts using a phillips head screwdriver. Do not over
tighten the bolts.
4 A) Insert 2 barrel nuts into left/right side panels and
partition as shown. Using a phillips head screwdriver,
align hole of each barrel nut with the nearest edge with
holes.
B) With the assistance of another adult, fit dowels of
assembled unit into corresponding holes of bottom panel.
Secure bottom panel with 6 large bolts as shown. Make
sure bolts securely engage each barrel nut.
back panel
2 A) Carefully place top panel onto a clean, padded
surface as shown. Fit dowels of top panel into correspond-
ing holes of left/right side panel and partition. Loosely
secure left/right side panel and partition to top panel with
2 small bolts as shown.
B) Insert 6 wood dowels into left/right side panels and
partition as shown.
A
B
top panel
NOTE: Make sure
hole of barrel nut
aligns with nearest
edge with holes
top panel
partition
left side
panel
right
side
panel
bottom
panel
A
B
A
NOTE: Do not over
tighten the bolts