Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
PACIFIC 4-DRAWER CHEST
Page 3 of 3
Made in Lithuania - r05
6 A. Attach left & right drawer sides to drawer
back with 4 large wood screws. Do not over tighten
the screws.
B. Slide drawer bottom panel into grooves in drawer
side and back panels. Make sure the cut-off corners
of the bottom panel face out as illustrated.
Repeat steps A & B for the remaining 3 drawers.
7 A. Insert 4 cams into holes in the front of the drawer
side panels.
B. Insert 4 cam screws into the drawer front. Fit drawer
front into position and secure all cams with a screwdriver.
C. Hold drawer knob in place while using a phillips head
screwdriver to tighten the large bolt.
D. Turn drawer assembly upside down and attach right
and left drawer glides with 4 small wood screws. Make
sure the wheels extend beyond the drawer back as shown.
Repeat Steps A-D for the remaining 3 drawers.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.
A
B
drawer
bottom panel
A
B
C
5 A. Insert 4 cam screws into the top panel and secure
with a flat head screwdriver.
B. Insert 4 cams into the tops of side panels. Fit top
panel into position and secure all cams with a phillips head
screwdriver.
C. Conceal all cams by inserting cam covers into all cams.
B
C
8 Insert 4 drawer assemblies into the case, aligning
wheels of drawer glides with rail of case glides.
Assembly is now complete.
View from
underside of
drawer assembly
D
Only these
2 holes are used
A
x 4
x 4