Assembly Instruction

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
OCTAVE NIGHTSTAND
Made in Vietnam - r03 Page 2 of 3
1 A) Fit pre-assembled dowels of side panels and
partitions into corresponding holes of top panel as shown.
Using a phillips head screwdriver, secure each panel with
2 large bolts, 2 spring washers and 2 flat washers as
shown. Do not over tighten the bolts.
B) Fit back panel into grooves of assembled unit as shown.
3 With the assistance of another adult, attach leg
assembly to bottom of assembled unit with 6 small bolts,
6 spring washers and 6 flat washers as shown. Secure
bolts with a screwdriver.
4 A) Fit drawer bottom into grooves of drawer back and
drawer front as shown. Fit dowels of drawer assembly
into corresponding holes of drawer sides. Secure with
4 small screws per side, using a screwdriver.
B) Attach 1 pull to drawer front with 2 pull bolts, using
a screwdriver.
Repeat step 4A-B for remaining drawer assembly.
A
large bolt
spring washer
flat washer
2 Fit dowels of assembled unit into corresponding
holes of bottom panel as shown. Secure, but do not
over tighten with 8 large screws, using a screwdriver.
back
panel
right side panel
right partition
left side panel
left partition
top panel
A
B
bottom panel
small bolt
spring washer
flat washer
drawer
back
drawer right
side
drawer left
side
drawer
front
pull
drawer
bottom
A
B
A
B
NOTE: Do not over
tighten the bolts
NOTE: Do not over
tighten the screws
leg
assembly
NOTE: Make
sure wheels are
at the back