Assembly Instruction

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
OCTAVE FOUR DRAWER CHEST
Made in Vietnam - r04 Page 2 of 3
1 A) With the assistance of another adult, fit back panel
into grooves of right side panel as shown.
B) Fit pre-assembled dowels of partition into corresponding
holes of right side panel as shown. Using a phillips head
screwdriver, secure right side panel with 2 medium bolts,
2 spring washers and 2 flat washers as shown. Do not
over tighten the bolts.
4 A) Fit dowels of assembled unit into corresponding
holes of top panel. Secure top panel with 4 medium
bolts, 4 spring washers and 4 flat washers as shown.
B) Secure top panel to back panel with 2 large bolts,
2 spring washers and 2 flat washers.
A
medium bolt
spring washer
flat washer
3 A) Fit dowels of assembled unit into corresponding
holes of bottom panel as shown. Secure, but do not
over tighten with 4 bottom screws, using a screwdriver.
B) Secure bottom panel to back panel from inside with 2
large bolts, 2 spring washers and 2 flat washers.
back
panel
right side
panel
partition
left side
panel
B
B
bottom panel
NOTE: Do not over
tighten the bolts
NOTE: Do not over
tighten the screws
A
B
B
A
top panel
A
B
A
B
large bolt
spring washer
flat washer
large bolt
spring washer
flat washer
medium bolt
spring washer
flat washer
bottom
screw
2 A) Fit back panel into grooves of left side panel as
shown.
B) Fit dowels of partition into corresponding holes of left
side panel and secure with 2 medium bolts, 2 spring
washers and 2 flat washers as shown.
A
back
panel
B
partition
medium bolt
spring washer
flat washer
B