Assembly Instruction

Page 5 of 5
NOTCH
BOOKCASE
Made in Vietnam - r07 Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
For added safety and stability, it is recommended that the wall
mounting hardware be installed. For safe mounting, it is essential
to use wall anchors appropriate to your wall type (i.e. plaster,
drywall, concrete, etc.). Mount to wood studs whenever possible.
A) Determine desired bookcase orientation, and attach wall
bracket to the appropriate pilot holes located on the underside of
top panel. Secure wall bracket with 2 small screws as shown.
B) Determine the final location of unit. Mark position on the wall,
approximately 2" below the wall bracket mounted to the back of
the unit.
C) Drill a hole in the wall stud. If the wall stud is not available, drill
a hole in the wall that is slightly smaller in diameter than the
anchor. Gently tap the plastic anchor until the flange of the
anchor is flush with the wall.
D) Attach wall bracket to the wall by inserting 2 large screws,
and into the plastic anchor in the wall.
E) Place the unit so the wall brackets on the back are aligned with
the wall brackets on the wall.
F) Lace one end of the wall strap through both brackets, and into
the other end of the strap.
G) Pull the strap tightly until secure.
Repeat steps A-G for remaining wall bracket and wall strap.
Wall mounting assembly is now complete.
NOTE: If you are unsure about
your wall type or what mounting
method you should use, consult
a qualified professional or your
local hardware store.
Safety Mounting Assembly
ORIENTATION 2ORIENTATION 1
WALL
WALL
A
C
D
F
NOTE: Secure wall
brackets to underside
of top panel as shown