Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
NEWPORT WALL MIRROR
HARDWARE
TOOLS REQUIRED
Phillips head screwdriver
Electric drill and drill bit
HANGING THE MIRROR:
Made in Vietnam 2004
Page 1 of 1
Thank you for purchasing the Newport wall mirror.
This page lists all the contents included in the box.
Please take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
2 - screws
2 - anchors
CLEANING AND CARE
Clean wood surfaces with a damp cloth. Do not use
furniture wax or polish as the wood is finished with a
protective clear lacquer.
31”
1/16”
NOT E : T his mirror c a n only be hung
horizontally. Although basic wall mounting
hardware is included, be sure to use the
proper hardware for your wall type. When in
doubt, consult your local hardware store.
1 Determine desired location of mirror and
mark the center of the two anchors on the
wall. The anchors will be 31" apart,
horizontally.
2 Drill two holes that are slightly smaller in
diameter than the anchor, but 1/4" deeper
than the length of the anchor.
3 Insert two anchors flush with the surface of
the wall. Gently tap with hammer if necessary.
4 Using screwdriver, secure the two screws
into the anchors leaving approximately 1/16"
of the screw head out from the wall as
illustrated.
5 Hang the mirror on the two screws.
mirror
screw
anchor
hole in wall
see step 4
Missing hardware? Please call 800.606.6387
for replacements.