Assembly Instruction

Made in China - r01
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
MOTEL DOUBLE GLIDER
Page 2 of 4
2 Attach 1 center support to 2 seat assemblies with 1
small bolt, 2 small washers and 1 lock nut as shown,
using an allen wrench.
seat
assembly
top crossbar
inner right
leg frame
inner left
leg frame
NOTE: Do not over
tighten the bolts
4 Position assembled inner leg frame as shown. With the
assistance of another adult, attach front crossbar to inner
left and right leg frames with 2 small bolts, 4 small
washers and 2 lock nuts as shown.
1 Place seat and seat back onto a clean, padded
surface. Attach seat to seat back with 4 small bolts, 8
small washers and 4 lock nuts as shown. Make sure
bolts are attached from the backside of seat back.
Secure, but do not over tighten the bolts and nuts, using
an allen wrench and a hex wrench. Repeat for remain-
ing seat and seat back.
seat
back
seat
seat
assembly
center
support
3 Fit ends of inner left and right leg frames into top
crossbar as shown.
front crossbar
inner right
leg frame
inner left
leg frame