Assembly Instruction

Customer Service 800.967.6696 | www.crateandbarrel.com
MADISON LARGE HUTCH
Made in Denmark - r03 Page 2 of 6
1 A) Insert 4 cam screws and 3 wood dowels into left and
right side panels as shown. Secure cam screws with a
phillips head screwdriver.
B) Position each hinge plate over corresponding holes in side
panels. Secure hinges with pre-attached bolts, using a
screwdriver.
2 A) Insert 4 cams and 4 wood dowels into bottom back
panel as shown. Make sure arrows on each cam point towards
nearest edge with holes.
B) Insert 4 cams and 6 wood dowels into bottom panel as
shown.
3 Fit dowels of bottom panel and bottom back
panel into corresponding holes of right and left side
panel as shown. With a screwdriver, turn cams
clockwise until it securely engages each cam screw.
4 Insert 6 wood dowels into 3 partitions as shown.
left and right
side panels
NOTE: Make sure
arrows on each cam
point towards nearest
edge with holes
right side
panel
left side
panel
bottom back
panel
B
bottom
panel
bottom
back panel
bottom
panel
partition
A
A
B