Assembly Instruction

Customer Service 800.967.6696 | www.crateandbarrel.com
MADISON CABINET
Made in Denmark - r06 Page 2 of 6
1 A) Insert 2 cam screws into 4 legs as shown. Secure
cam screws with a phillips head screwdriver.
B) Insert 2 cams and 4 large wood dowels into 2 long
aprons as shown. Make sure arrows on each cam point
towards nearest edge with holes.
2 A) Fit dowels of long aprons into corresponding holes of
legs as shown. With a screwdriver, turn cams clockwise until
they securely engage each cam screw.
B) Gently tap 4 glides into leg assembly with a hammer as
shown.
3 A) Insert 2 cams and 4 large wood dowels into 2
short aprons as shown.
B) Fit dowels of short aprons into corresponding
holes of leg assembly as shown. Secure 4 cams. Set
leg assembly aside until further instructions.
4 Place bottom panel face down onto a clean,
padded surface as shown. Attach leg assembly to
bottom panel with 8 large screws as shown. Secure
screws with a screwdriver.
leg
long
apron
NOTE: Make sure
arrows on each cam
point towards nearest
edge with holes
long
apron
leg
short
apron
short
apron
leg
assembly
leg
assembly
bottom
panel
4 A) Insert 4 shelf cams into fixed shelf as shown. Make sure
open end of each cam is towards nearest panel edge.
B) Insert 2 shelf screws and 6 small wood dowels into left and
right side panels as shown. Secure cam screws with a screwdriver.
C) Attach 4 hinge plates to left and right side panels as shown.
With a screwdriver, secure hinge plates with pre-attached bolts.
fixed
shelf
left and
right side
panels
A
B
C
NOTE: Make sure
open end of each cam
is towards nearest
panel edge
glide
A
B
A
B
A
B