Assembly Instruction

Made in China r08 Page 4 of 4
11 A) Secure underside of drawer bottom to drawer back
with 3 black screws. Secure, but do not over tighten with
the phillips head screwdriver.
B) Fit drawer pull into position as shown and secure with 2
silver screws.
Repeat Steps 8 - 11 for remaining 2 drawers.
12 A) Fully extend drawer glides from assembled unit as
shown.
B) Position drawer assembly and rest the drawer assembly
on top of the tabs as shown. Attach each glide to drawer with
2 glide screws as shown. Secure with a screwdriver. Repeat
steps for each drawer.
C) Conceal all exposed cams with cam covers.
Assembly is now complete.
LOOP 3 DRAWER CHEST
9 Slide drawer back into vertical slots at rear of drawer
sides.
10 Slide drawer bottom into slot at base of drawer sides
and drawer front. Make sure pilot holes are at the back of the
drawer bottom as shown.
These holes at back
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.
B
A
A
B
B
C
Customer Service 800.967.6696 | www.crateandbarrel.com