Assembly Instruction

Made in China r11 Page 5 of 5
13 A) Secure underside of drawer bottom to drawer
back with 2 black screws. Secure, but do not over
tighten with the phillips head screwdriver.
B) Fit drawer pull into position as shown and secure with
2 silver screws.
Repeat Steps 8 - 11 for remaining 5 drawers.
14 A) Fully extend drawer glides from
assembled unit as shown.
B) Position drawer assembly and rest the
drawer assembly on top of the tabs as
shown. Attach each glide to drawer with 2
glide screws as shown. Secure with a
screwdriver. Repeat steps for each drawer.
C) Conceal all exposed cams with cam
covers.
Assembly is now complete.
LOOP 6 DRAWER DRESSER
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not
use abrasive cleaners. Do not use furniture wax or
polish as the wood is finished with a protective clear
lacquer.
C
A
A
B
Customer Service 800.967.6696 | www.crateandbarrel.com
12 Slide drawer bottom into slot at base of drawer
sides and drawer front. Make sure pilot holes are at the
back of the drawer bottom as shown.
These holes at back
NOTE: Drawers labeled “LEFT”
on the back of drawer front are to
be placed into the left side of the assembly.
Drawers labeled “RIGHT” are to be placed
into the right side of the assembly.
B
B