Assembly Instruction

Made in China r11 Page 2 of 5
3 Insert 5 wood dowels and 6 cams into middle partition
as shown.
4 Fit cam screws of back panel into corresponding holes in
the middle partition.
LOOP 6 DRAWER DRESSER
1 A) Place left side panel face down on a padded surface.
Insert 4 cam screws into the holes as shown. Secure, but do
not over tighten with a phillips head screwdriver.
B) Insert 3 cams into the large holes as shown, making sure
the arrow on each cam points towards the nearest edge with
holes.
C) Insert 2 wood dowels into the top edge of the panel.
Repeat Steps A, B & C for the right side panel.
2 A) Insert 6 wood dowels, 3 cam screws, and 10 cams
into back panel as shown.
B) Insert 2 wood dowels and 2 cams into crossbar as shown.
Back Panel
Crossbar
Arrow on each
cam points towards
edge with holes
A
B
A
B
C
middle
partition
middle
partition
back
panel
Customer Service 800.967.6696 | www.crateandbarrel.com