Assembly Instruction

LOOP DESK
Made in China - r08 Page 2 of 3
NOTE: Do not over tighten the cam screws or bolts
right
side
panel
B
1 A) With the assistance of another adult, carefully pull out
drawer from desktop assembly as shown. Set drawer aside.
B) Insert 4 cams into desktop assembly as shown. Make sure
arrows on each cam points toward the nearest edge with holes.
C) Insert 2 cam screws and 2 wood dowels to right side panel
as shown. Secure, but do not over tighten, the cam screws using
a phillips head screwdriver.
D) Fit dowels of right side panel into corresponding holes of
each side frame. Using a screwdriver, turn each cam clock-
wise until it securely engages the cam screws.
E) Secure left side frame to desktop assembly with 3 bolts,
using an allen wrench.
C
C
D
E
desktop
assembly
drawer
cam
screws
wood
dowels
bolts
E
A
cams
D
NOTE: Make sure
arrows on each cam
point towards
nearest edge with
holes
2 A) Insert 2 cam screws and 2 wood dowels to left side
panel.
B) Insert 1 cam screw and 1 wood dowel into left and right
side panel as shown.
C) Insert 2 cams into crossbar as shown.
D) Fit dowel of right side panel into corresponding hole of
A
A
B
C
D E
right side
panel
left side
panel
crossbar
desktop
assembly
E
crossbar as shown. Then, fit dowels of left side panel into
corresponding holes of crossbar and desktop assembly as
shown. At this point, secure cams of crossbar and left side
panel.
E) Secure left side frame to desktop assembly with 3 bolts.
At the point, insert drawer into desktop assembly as shown.
D
Customer Service 800.967.6696 | Latest instructions available on www.crateandbarrel.com
B
B