Assembly Instruction

NOTE:
This plasma back panel is intended for
placement against a wall using
the enclosed anchoring hardware.
The included hardware is for
mounting the unit to drywall.
Use hardware appropriate to
your wall type.
Short
wood
screw
Wall
anchor
strap
Long
wood
screw
Plastic
wall
anchor
Wall
2 A) Drill a hole in the wall slightly
smaller than the diameter of the
plastic wall anchor. Lightly tap with a
hammer until the face is flush with the
wall.
B) Insert long wood screw through
wall anchor strap and into the wall
anchor.
C) Insert short wood screw through
wall anchor strap and into the top of
unit.
Assembly is now complete.
NOTE: Insert screws 3/4"-1"
from the edge of the strap
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth.
Do not use abrasive cleaners. Do not use furniture
wax or polish as the wood is finished with a
protective clear lacquer.
Made in China - r04 Page 2 of 2
LOOP PLASMA BACK PANEL
Customer Service 800.967.6696 | www.crateandbarrel.com
NOTE: Contact your television manufacturer to
find out the necessary wall mounting bracket and
instructions needed to safely mount your TV.