Assembly Instruction

LEDGE 6 DRAWER DRESSER
Made in Malaysia - r10 Page 2 of 4
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
2 A) Attach base assembly to bottom panel with 12
large screws as shown. Secure, but do not over
tighten, screws using a phillips head screwdriver.
B) Attach support leg to bottom panel by turning
support leg clockwise.
C) Adhere 5 adhesive feet to legs as shown.
base
NOTE: Do not over
tighten screws
bottom panel
A
B
support leg
adhesive
foot
A
left and right
side panels
1 A) Place left and right side panels onto a clean,
padded surface. Insert 6 wood dowels into left and right
side panels as shown.
B) Insert 2 cam screws into left and right side panels as
shown. Secure, but do not over tighten, cam screw with a
phillips head screwdriver.
C) Insert 4 cams into partition as shown.
B
NOTE: Do not over
tighten the cam screw
right
side
panel
left
side
panel
left front
crossbar
4 With the assistance of another adult, fit dowels of front
and back crossbars into corresponding holes of
left/right side panel and partition as shown. Using a
screwdriver, turn each cam clockwise until it securely
engages each cam screw.
left back
crossbar
3 Insert 2 wood dowels and 2 cams into front and back
crossbars as shown. Make sure arrows on each cam
point towards nearest edge with holes.
NOTE: Make sure arrows
on each cam point towards
nearest edge with holes
front
crossbar
partition
partition
back
crossbar
right front
crossbar
right back
crossbar
C