Assembly Instruction

LEDGE 4 DRAWER CHEST

Made in Malaysia - r09 Page 5 of 5

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

For added safety and stability, it is recommended that the

wall mounting hardware be installed. For safe mounting, it is

essential to use wall anchors appropriate to your wall type

(i.e. plaster, drywall, concrete, etc.). Mount to wood studs

whenever possible.

A) Attach 2 wall brackets to back of unit using 2 small

screws as shown.

B) Determine the final location of unit. Mark position on the

wall, approximately 2" below each wall bracket mounted to

the back of the unit.

C) Drill a hole in the wall stud. If the wall stud is not

available, drill a hole in the wall that is slightly smaller in

diameter than the anchor. Gently tap the plastic anchor

until the flange of the anchor is flush with the wall.

D) Attach wall brackets to the wall by inserting 1 large

screws through each bracket and into each plastic anchor in

the wall, secure with a screwdriver.

E) Place the unit so the wall brackets on the back edge are

aligned with the wall brackets on the wall.

F) Lace one end of the wall straps through each bracket,

and into the other end of the strap.

G) Pull the strap tightly until secure.

Wall mounting assembly is now complete.

SAFETY MOUNTING INSTRUCTIONS:

NOTE:

If you are unsure about your wall type

or what mounting method you should

use, consult a qualified professional

or your local hardware store.

wall

bracket

plastic

anchor

large

screw

wall

strap

wall

bracket

WALL

small

screw