Assembly Instruction

LEDGE 4 DRAWER CHEST

Made in Malaysia - r09 Page 2 of 5

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

left and right

side panels

1 A) Place left and right side panels onto a clean,

padded surface. Insert 6 wood dowels into left and right

side panels as shown.

B) Insert 1 cam screw into left and right side panels as

shown. Secure, but do not over tighten, cam screw with a

phillips head screwdriver.

2 A) Attach base assembly to bottom panel with 10

large screws as shown. Secure, but do not over

tighten, screws using a phillips head screwdriver.

B) Adhere 4 adhesive pads to legs of base as shown.

base

NOTE: Do not over

tighten screws

bottom panel

3 Insert 2 wood dowels and 2 cams into crossbar as

shown. Make sure arrows on each cam point towards

nearest edge with holes.

NOTE: Make sure arrows

on each cam point towards

nearest edge with holes

crossbar

NOTE: Do not over

tighten the cam screw

right

side

panel

left

side

panel

crossbar

4 With the assistance of another adult, fit dowels of

crossbar into corresponding holes of left and right side

panel as shown. Using a screwdriver, turn each cam

clockwise until it securely engages each cam screw.

adhesive

pad