Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
LATITUDE MEDIA STAND
Made in Denmark 2004
Page 2 of 6
3 A. Insert 4 large cams into underside of shelf, making
sure arrows on each cam point towards the shelf edge.
B. Insert 2 dowels into inner holes of left side panel.
1 Fully extend the drawer glide. Position the first hole at
the back end of the glide over the pre-drilled hole in the left
side panel. Attach back of glide with 1 short wood screw.
2 Retract the glide as shown. Position 1 short wood screw
over the oval hole on the external portion of the glide and
through the third hole on the inside portion of the glide.
Secure the front of the glide by fastening the short wood
screw into the pre-drilled hole.
Repeat these steps for the right side panel.
4 A. Using a screwdriver, fasten 2 cam screws into
the outer holes of the left side panel.
B. Slide shelf over cam screws and dowels.
A
B
A
B
Shelf
(underside)
Make sure
arrow on
drawer slide
points forward
Left Side
Panel
Make sure this
arrow points
towards holes
in the shelf
edge
Left Side
Panel