Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
5 A. Insert 4 wood dowels into the outer holes on edges
of each back panel.
B. Insert 4 cams into each back panel, making sure
arrows on cams points towards nearest edge.
C. Insert 6 wood dowels into outer holes on edge of
divider panels.
D. Insert 2 cam screws into the inner holes at the rear of
each divider panel.
7 A. Insert 4 wood dowels into the outer holes on the
edges of the middle back panel.
B. Fit middle back panel onto cam screws of each divider
panel. Secure all 4 cams with a phillips head screwdriver.
LATITUDE LARGE MEDIA STAND
Page 3 of 5
Made in Denmark - r09
Divider
Panel
Back
Panel
A
B
C
6 Fit left side and divider panel onto back panel, aligning
cam screws and dowels with corresponding holes. Using a
phillips head screwdriver, turn all 4 cams on the back panel
clockwise until each cam tightly engages the cam screw.
Repeat for remaining right side, back and divider panel.
Left
Side
Panel
Divider
Panel
Back
Panel
D
8 With the assistance of another adult, carefully lift each
back panel assembly and place into position on bottom
panel. Make sure dowels and cam screws on each panel are
aligned with their corresponding holes.