Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
3 A. Insert 12 cam screws into the inner holes of the top
panel. Secure, but do not over tighten with a screwdriver.
B. Insert 12 cam screws into the inner holes of the bottom
panel and secure with a screwdriver.
1 Place 4 legs at each corner of the base frame, aligning
hole in leg with hole in bracket. Attach with 1 leg bolt per
leg, fully tightening with a phillips head screwdriver.
2 Position base frame assembly over holes in the bottom
panel. Insert 12 wood screws through holes in frame and
into bottom panel and secure with a screwdriver.
4 A. Insert 6 wood dowels in the outer holes on the edge
of each side panel.
B. Insert 6 cams into each side panel, making sure arrow of
each cam points out towards nearest edge with dowels.
C. Fasten 2 cam screws at rear inner hole on each side
panel with a phillips head screwdriver.
D. Attach 2 case hinges to each side panel with 2 hinge
screws. Use the top 2 holes for the top case hinge and the
bottom 2 holes for the bottom case hinge as shown.
A
B
Make sure arrow
on each cam
points to nearest
edge with
dowels
LATITUDE LARGE MEDIA STAND
Page 2 of 5
Made in Denmark - r09
Top
Panel
Bottom
Panel
Side
Panel
B
C
A
D
NOTE:
Do not over tighten the screws.