Assembly Instruction

A
Made in Indonesia - r08 Page 2 of 2
KIPLING BUFFET AND HUTCH TOP
D
wall fitting &
small screw
Customer Service 800.967.6696 | www.crateandbarrel.com
For added safety and stability, it is recommended that the
wall mounting hardware be installed. For safe mounting, it
is essential to use wall anchors appropriate to your wall type
(i.e. plaster, drywall, concrete, etc.). Mount to wood studs
whenever possible.
A) Attach 2 wall fittings to top of hutch as shown, using 1
small screw per bracket.
B) Determine the final location of hutch. Mark position on
the wall, approximately 2" below the bracket mounted to the
back of the hutch.
C) Drill a hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller in
diameter than the anchor. Gently tap the plastic anchor
until the flange of the anchor is flush with the wall.
D) Attach the wall fitting to the wall by inserting 1 large
screw through the wall fitting and into the plastic anchor in
the wall.
E) Place the unit so the wall fitting on the back edge is
aligned with the wall fitting on wall.
F) Lace one end of the wall strap through both fittings, and
into the other end of the strap.
G) Pull the strap tightly until secure. Repeat steps for
remaining fitting and wall strap.
Assembly is now complete.
NOTE:
If you are unsure about your wall type or what
mounting method you should use, consult a
qualified professional or your local hardware
store.
C
F
large
screw
wall strap
plastic
anchor
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth.
Do not use abrasive cleaners. Do not use furniture
wax or polish as the wood is finished with a
protective clear lacquer.
1 With assistance of another adult, carefully place hutch
onto buffet as shown. Attach 2 connecting brackets to
back of assembled unit with 3 small screws per bracket
as shown. Secure screws with a phillips head screw-
driver.
hutch
buffet
ASSEMBLY WITH HUTCH
WALL MOUNTING ASSEMBLY WITH HUTCH