Assembly Instruction

KINGSTON TALL CABINET
Page 2 of 4
Made in Vietnam - r05 Customer Service 800.967.6696 | Latest instructions available on www.crateandbarrel.com
1 A) Insert 2 cam screws into left panel as shown.
Secure with a Phillips head screwdriver, but do not
over tighten cam screws. Repeat step for right
panel.
B) Insert 4 cams into holes located on bottom panel.
Make sure arrows on each cam point towards nearest
edge with holes.
2 A) Attach left and right side panels onto bottom
panel and fixed shelf by aligning cam screws with
corresponding holes. Secure fixed shelf as shown
with 4 bolts, 4 spring washers, and 4 flat washers
using a Phillips head screwdriver.
B) Secure cams using a Phillips head screwdriver.
Turn each cam clockwise until it securely engages
each cam screw.
3 With assistance of another adult, carefully fit front
frame onto assembled unit by aligning dowels with
corresponding holes as shown. Secure front frame
with 8 bolts, 8 spring washers, and 8 flat washers
using a Phillips head screwdriver.
4 A) With assistance of another adult, carefully
place unit upright. Fit top panel onto assembled unit
by aligning dowels with corresponding holes. Secure
top panel with 6 bolts, 6 spring washers, and 6 flat
washers using a Phillips head screwdriver.
B) Attach pull onto front frame as shown with 2 pull
screws. Secure with Phillips head screwdriver.
A
B
Make sure arrows
on each cam point
towards nearest edge
with holes.
A
A
A
B
VIEW FROM BELOW
B