Assembly Instruction

KINGSTON SLIDING DOOR COFFEE TABLE
Made in China - r04 Page 2 of 2
1 Insert 2 cam screws into back panel as shown.
Secure, but do not over tighten with a phillips head
screwdriver. Insert 2 cams into bottom panel as shown.
Make sure arrow on each cam points towards nearest
edge with holes. Fit cam screws and dowels of back
panel into corresponding holes of bottom panel. With a
screwdriver, turn each cam clockwise until it securely
engages each cam screw.
2 A) Insert 4 cams into bottom panel as shown. Insert 2 cam
screws into each left and right side panel as shown.
B) Fit left and right side panel onto back and bottom panel
assembly by fitting cam screws and dowels into corresponding
holes as shown. With a screwdriver, turn each cam clockwise until
it securely engages each cam screw. Secure side panels with 4
bolts, 4 spring washers, and 4 flat washers as shown, using a
screwdriver.
Make sure arrow on each
cam points towards nearest
edge with holes.
3 With the assistance of another adult, carefully
attach top panel onto assembled unit as shown with 8
bolts, 8 spring washers and 8 flat washers.
4 With the assistance of another adult, carefully place unit
upright. Insert bottom edge of right door into bottom back
groove of unit as shown. Press and hold down both levers
(located at the back of door) to insert top edge of door into
top back groove of unit. Release levers to secure door.
Repeat for left door using the front groove of unit.
Assembly is now complete.
A
B
right
side door
left
side door
A
B
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.
Customer Service 800.967.6696 | www.crateandbarrel.com