Assembly Instruction

HARDWARE

TOOLS REQUIRED

COMPONENTS

Made in China R04 Page 1 of 3

Thank you for purchasing the Kingston Low Cabinet.

This page lists all the contents included in the box.

Please take time to identify the hardware as well as the

individual components of this product. As you unpack

and prepare for assembly, place the contents on a

carpeted or padded area to protect them from damage.

Note: 2 people are required to safely assemble this product.

KINGSTON LOW CABINET

Missing hardware? Please call 800.606.6387 for replacements.

6 - cams 6- cam

screws

19 - screws2- pulls

4 - pull

screws

18 - bolts 18- spring

washers

1- shelf

18- flat

washers

1 - front frame

Phillips head screwdriver

1 - top panel

1 - bottom panel 1 - fixed shelf

1 - center support1 - right panel

1 - back panel

1 - left panel

Customer Service 800.967.6696 | www.crateandbarrel.com

PAGE 1
KINGSTON LOW CABINET HARDWARE Thank you for purchasing the Kingston Low Cabinet. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage. Note: 2 people are required to safely assemble this product.
PAGE 2
KINGSTON LOW CABINET Make sure arrows on each cam point towards nearest holes on edge of panel. A B 1 A) Insert 2 cam screws into left side panel as shown. Secure with a Phillips head screwdriver, but do not over tighten cam screws. Repeat step for right side panel. B) Insert 4 cams in holes located on bottom panel. Make sure arrows on each cam point towards nearest edge with holes.
PAGE 3
KINGSTON LOW CABINET VIEW FROM BELOW 5 Attach assembled unit onto top panel as shown, by aligning holes with corresponding wood dowels. Secure with 8 bolts, 8 spring washers, and 8 flat washers using a Phillips head screwdriver. 6 Attach back panel onto assembled unit as shown, with 19 screws. Secure with a Phillips head screwdriver, but do not over tighten the screws. B A CLEANING AND CARE Back of front frame Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners.