Assembly Instruction

KINGSTON CORNER MEDIA STAND

Made in Vietnam - r06 Page 2 of 3

1 NOTE: In steps 1-5, unit is assembled upside down.

A) Attach bottom panel and shelf panel onto left and right

side panels as shown with 2 spring washers, 2 flat

washers, and 2 bolts per panel. Secure with a Phillips

head screwdriver, but do not over tighten the bolts.

B) Attach back panel onto assembled unit as shown with 4

spring washers, 4 flat washers, and 4 bolts.

2 Attach left and right angled panels onto assembled unit

as shown by aligning pre-installed dowels with

corresponding holes. Secure with 8 spring washers, 8 flat

washers, and 8 bolts using a Phillips head screwdriver.

4 A) Insert 2 cam screws into front frame as shown.

Secure with Phillips head screwdriver, but do not over

tighten.

B) Attach front frame onto assembled unit by aligning cam

screws and dowels with corresponding holes. Secure frame

with 4 spring washers, 4 flat washers, and 4 bolts using a

Phillips head screwdriver.

3 Insert 2 cams into assembled unit as shown. Make

sure arrows on each cam points towards the nearest edge

with holes.

NOTE: Do not over

tighten the bolts.

NOTE: Make sure arrows

on each cam points towards

the nearest edge with holes.

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

VIEW FROM BELOW