Assembly Instruction

ManualsBrandsCrate & Barrel ManualsTablesCrate & Barrel Kingston Bunching Table

Made in China - r06 Page 1 of 2

Thank you for purchasing the Kingston Bunching

Table. This page

lists all the contents included in the

box. Please take the time

to identify the hardware as

well as the individual components

to this product. As

you unpack and prepare for assembly, place the

contents on a carpeted or padded area to protect them

from damage.

Note: 2 people are required to safely assemble this product.

TOOLS REQUIRED

Missing hardware?

Please call 800.606.6387 for replacements.

HARDWARE

COMPONENTS

KINGSTON BUNCHING TABLE

1 - front

frame

2 - side panels

(1 left, 1 right)

1 - back

panel

1 - bottom

panel

1 - top

panel

1 A) Insert 4 cams into bottom panel as shown.

Make sure arrow on each cam points towards nearest

edge with holes.

B) Insert 2 cams screws into left and right side

panels. Secure cam screws, but do not over tighten

with a phillips head screwdriver.

Make sure arrow

on each cam points

toward nearest edge

with holes

13 - bolts 13 - spring

washers

13 - flat

washers

4 - cams 4 - cam

screws

phillips head screwdriver

Customer Service 800.967.6696 | www.crateandbarrel.com

Summary of content (2 pages)

PAGE 1
KINGSTON BUNCHING TABLE HARDWARE 13 - bolts 13 - spring washers 4 - cams 4 - cam screws 13 - flat washers Missing hardware? Please call 800.606.6387 for replacements. Thank you for purchasing the Kingston Bunching Table. This page lists all the contents included in the box. Please take the time to identify the hardware as well as the individual components to this product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage.
PAGE 2
KINGSTON BUNCHING TABLE front frame right side panel B B A bottom panel left side panel 2 Fit cam screws of left and right side panels and dowels of bottom panel into corresponding holes as shown. Using a screwdriver, turn each cam clockwise until it securely engages each cam screw. back panel A 3 A) Carefully place back panel onto a clean, padded surface as shown. Fit dowels of assembled unit into corresponding holes of back panel as shown.