Assembly Instruction

KINGSTON 52” MEDIA STAND
Made in Vietnam - r07 Page 2 of 3
Customer Service 800.967.6696 | Latest instructions available on www.crateandbarrel.com
1 A) Insert 2 cam screws into left side panel as
shown. Secure with a Phillips head screwdriver,
but do not over tighten cam screws. Repeat step for
right side panel.
B) Insert 4 cams into holes located on bottom panel.
Make sure arrows on each cam point towards nearest
edge with holes.
2 A) Attach middle partition and bottom panel by
aligning holes with pre-assembled dowels. Secure
middle partition with 2 large screws using a Phillips
head screwdriver. Do not over tighten the screws.
B) Attach center support onto bottom panel by
aligning holes with pre-assemble dowels. Secure
center support with 2 bolts, 2 spring washers, and
2 flat washers using a Phillips head screwdriver.
3 A) Carefully fit left and right side panels onto
assembled unit by aligning cam screws and dowels
with corresponding holes.
B) Secure cams using a Phillips head screwdriver.
Turn clockwise until each cam securely engages each
cam screw.
A
B
A
B
NOTE: Do not over
tighten the screws.
Make sure arrows
on each cam point
towards nearest edge
with holes.
B
B
A
4 Attach top panel onto assembled unit by aligning
holes with pre-assembled dowels. Secure left side
panel, right side panel, and middle partition with 6
bolts, 6 spring washers, and 6 flat washers using a
Phillips head screwdriver.