Assembly Instruction

HARDWARE

TOOLS REQUIRED

COMPONENTS

Made in Vietnam - r07 Page 1 of 3

Thank you for purchasing the Kingston 52” Media

Stand. This page lists all the contents included in the

box. Please take time to identify the hardware as well as

the individual components of this product. As you

unpack and prepare for assembly, place the contents on

a carpeted or padded area to protect them from damage.

Note: 2 people are required to safely assemble this product.

KINGSTON 52” MEDIA STAND

Missing hardware? Please call 800.606.6387 for replacements.

4 - cams 4- cam

screws

20 - screws

8 - bolts 2 - large

screws

16- shelf

pins

8 - flat

washers

Phillips head screwdriver

8 - spring

washers

Customer Service 800.967.6696 | Latest instructions available on www.crateandbarrel.com

1 - top panel

1 - bottom panel

4 - adjustable

shelves

1 - left side

panel

1 - right side

panel

1 - right sliding

door panel

1 - left sliding

door panel

1 - middle

partition

1 - back panel

1 - center

support

PAGE 1
KINGSTON 52” MEDIA STAND HARDWARE Thank you for purchasing the Kingston 52” Media Stand. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage.
PAGE 2
KINGSTON 52” MEDIA STAND B A B A B NOTE: Do not over tighten the screws. Make sure arrows on each cam point towards nearest edge with holes. 1 A) Insert 2 cam screws into left side panel as shown. Secure with a Phillips head screwdriver, but do not over tighten cam screws. Repeat step for right side panel. B) Insert 4 cams into holes located on bottom panel. Make sure arrows on each cam point towards nearest edge with holes.
PAGE 3
KINGSTON 52” MEDIA STAND A A B 6 Attach back panel onto assembled unit as shown, with 20 screws. Secure with a Phillips head screwdriver. 7 A) Insert 16 shelf pins into assembled unit at desired shelf levels. Press firmly to secure. B) Place 4 adjustable shelves into assembled unit. ADJUSTING THE LEVELERS If the doors do not appear square or aligned, try adjusting the levelers on the bottom of each leg. 8 Fit the bottom rollers of the right sliding door panel into back groove.