Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
KENTON DOUBLE CUBE WITH 2 DRAWERS
Page 2 of 3
Made in China - r07
5 Repeat Steps 3 and 4 for attachment of the top panel.
Be sure that back panel is seated in the slot at the back
of the top panel before securing the 4 cams.
3 A. Insert 4 cam screws in both end panels. Secure, but do
not over tighten with a phillips head screwdriver.
B. Place side panels into position over 1 bottom panel,
making sure slots on side panels line up with slot on bottom
panel. Align dowels and cam screws and firmly press into
position.
C. Slide back panel into the corresponding slot in the bottom
& side panels.
2 Remove the small component of each glide assembly.
Attach 2 of the large glides to the left and right side panels
with 3 small screws per glide, orienting each glide as
shown. The front of each glide should sit approximately
3/4" from the front edge of the panel. Secure, but do not
over tighten each screw with a phillips head screwdriver.
4 Using a phillips head screwdriver, turn each cam
at the base of the side panels clockwise until each
cam tightly engages the cam screw.
A
B
Cam in
unlocked
position
Cam in
locked
position
NOTE:
Do not over tighten
the screws.
Depress
plastic tab
to detach
small glide
from large
glide
assembly
C