Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
KENTON CUBE WITH 2 DRAWERS
Page 3 of 3
Made in China - r07
7 A. Attach right drawer side to drawer assembly with 4
large screws.
B. Attach drawer front to drawer assembly with 4 large
screws.
C. Attach drawer pull to drawer front with 2 pull screws.
Repeat Steps A-C for remaining drawer.
6 A. Attach left drawer side to drawer back and inner
drawer front with 4 large screws. Make sure unfinished
edge faces forward. Secure, but do not over tighten each
screw with a phillips head screwdriver.
B. Slide drawer bottom into slot at bottom of assembly.
Repeat Steps A & B for the other drawer.
8 Using a phillips head screwdriver, fasten the
small glide from each glide assembly to each drawer
side with 3 small screws. Make sure the front of the
drawer glide fits snug to the back of the drawer front.
Do not over tighten the screws.
A
B
B
A
C
NOTE:
Make sure front of
the drawer glide
fits snug to the
back face of the
drawer front.
IMPORTANT:
Make sure
unfinished
edge of
drawer
side faces
forward
9 Fit small drawer glide hardware into corresponding large
glide hardware on the case interior. Applying even pressure to
each side of the drawer front, firmly push drawer glides into
the case glides.
If the drawer fronts appear uneven or misaligned, open each
drawer. Loosen each drawer slide screw enough to allow for
movement of the drawer. Make any necessary adjustments to
the drawers and re-tighten the drawer glide screws.
Assembly is now complete.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.