Assembly Instruction

Made in Vietnam - r04 Page 3 of 3
KENDEL
44” TWO DRAWER CASE
4 Safety Mounting Instructions
For added safety and stability, it is recommended that the
wall mounting hardware be installed. For safe mounting, it is
essential to use wall anchors appropriate to your wall type
(i.e. plaster, drywall, concrete, etc.). Mount to wood studs
whenever possible.
A) Locate pilot holes on back of unit, and attach 1 bracket
using 2 medium screws as shown.
B) Determine the final location of unit. Mark position on the
wall, approximately 2" below the wall bracket mounted to the
back of the unit.
C) Drill a hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller in
diameter than the plastic anchor. Gently tap the plastic
anchor until the flange of the anchor is flush with the wall.
D) Attach 1 bracket to the wall by inserting 2 large screws
trough the bracket and into the plastic anchors in the wall.
E) Place the unit so the wall brackets on the back edge are
aligned with the wall brackets on the wall.
F) Lace one end of the wall strap through both brackets,
and into the other end of the strap.
G) Pull the strap tightly until secure.
H) Repeat steps A-G for remaining wall brackets and wall
straps.
NOTE:
If you are unsure about your wall type or
what mounting method you should use,
consult a qualified professional or your
local hardware store.
A
C
medium
screw
bracket
plastic
anchor
large
screw
wall
strap
D
F
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
WALL MOUNTING ASSEMBLY FOR MULTIPLE UNITS
bracket