Assembly Instruction

Made in Vietnam - r05 Page 4 of 4

KENDEL

44” OPEN BOOKCASE

5 Safety Mounting Instructions

For added safety and stability, it is recommended that the wall

mounting hardware be installed. For safe mounting, it is

essential to use wall anchors appropriate to your wall type (i.e.

plaster, drywall, concrete, etc.). Mount to wood studs whenever

possible.

A) Locate pilot holes on back of unit and attach 1 bracket

using 2 medium screws as shown.

B) Determine the final location of unit. Mark position on the

wall, approximately 2" below the wall bracket mounted to the

back of the unit.

C) Drill a hole in the wall stud. If the wall stud is not available,

drill a hole in the wall that is slightly smaller in diameter than the

plastic anchor. Gently tap the plastic anchor until the flange of

the anchor is flush with the wall.

D) Attach 1 bracket to the wall by inserting 2 large screws

through the bracket and into the plastic anchors in the wall.

E) Place the unit so the wall brackets on the back edge are

aligned with the wall brackets on the wall.

F) Lace one end of the wall strap through both brackets, and

into the other end of the strap.

G) Pull the strap tightly until secure.

H) Repeat steps A-G for remaining wall brackets and wall

straps.

NOTE:

If you are unsure about your wall type or what

mounting method you should use, consult a

qualified professional or your local hardware

store.

medium

screw

bracket

plastic

anchor

large

screw

wall

strap

bracket

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

CLEANING & CARE

Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Do not use furniture wax or polish as the unit

is finished with a protective clear lacquer. It is recommended to use coasters to protect surface from heat and water.

WALL MOUNTING ASSEMBLY FOR MULTIPLE UNITS